Using Settings Stored As A Program; Using A Program - Sharp MX-B350W User Manual

FACSIMILE►CONVENIENT FAX FUNCTIONS

USING SETTINGS STORED AS A PROGRAM

This function allows you to store the steps of an operation, including the destination and scanning settings, into a
program. This function is convenient when you frequently send documents, such as a daily report, to the same
destination. Up to 9 programs for fax transmission can be stored.
When storing a program, a name (maximum 36 letters) can be assigned to the program.
For information on storing, editing, and deleting programs, see
(page 4-43).
The following settings can be stored in a program:
(1) Address setting
(2) Transmission method
Normal transmission ►page
transmission ►page 4-30, polling
polling ►page 4-33
(3) Original Size Enter
When storing a broadcast transmission or serial polling operation in a program, up to 200 destination fax numbers can
be stored.
• A program differs from a timer transmission
place. A program thus allows you to repeatedly perform the same type of transmission. Note, however, that programs do
not allow you to establish a timer setting for transmission.
• A setting that can be stored in a program cannot be changed at the time that a program is used for a transmission even if
the setting is not stored in the program.
• The only settings that can be selected when using a program are the original size enter, duplex scanning, and a timer
setting.

USING A PROGRAM

In fax mode, place the original and select "Program" with the [ ] or [ ] key.
1
2
If needed, select the original size and other settings, and then press the
3
[START] key.
• Transmission takes place according to the program.
• If you selected a program that does not include a transmission method, set the transmission method and the
destinations to be dialed before pressing the [START] key.
Select settings that cannot be stored in a program before you press the [START] key in step 3. These settings include
the original size (see
TWO-SIDED ORIGINAL (page
(page 4-29)).
4-8, broadcast
►page 4-32, serial
(►page 4-29)
Select the program that you wish to use.
If not all letters of the program name appear, press the [READ-END] key (
all letters. Press the [READ-END] key (
BASIC PROCEDURE FOR SENDING FAXES (page
4-14)), and a timer setting (see
STORING, EDITING AND DELETING PROGRAMS
(4) Duplex Scanning
(5) Resolution and exposure
(6) Own number sendings
(7) Transmission settings
in that it is not cleared from memory after transmission takes
) once again to return to the original screen.
4-8)), duplex scanning (see
AUTOMATIC TRANSMISSION AT A SPECIFIED TIME
4-49
►page 4-46
►page 4-15
) to display
FAXING A