Indicators And Display Messages - Sharp MX-B350W User Manual

TROUBLESHOOTING►TROUBLESHOOTING

INDICATORS AND DISPLAY MESSAGES

If one of the following messages appears in the display, take prompt action as instructed by the message.
Message
Maintenance
Maintenance required. Call for service.
Call for service. –
Toner Low.
(Do not replace cartridge
until requested.)
Check the toner cartridge.
Change the toner cartridge.
Remove paper from the center tray.
Load < > paper into tray < >.
< >: Tray number
< >: Size of paper that should be loaded
And if one of the following error codes appears in the display at communication error when sending the scanned image,
take corresponding solution as mentioned below.
Error
Code
Turn off the power and then turn it back on. Consult with your network administrator to make sure
CE-00
that no problems exist on the network or in the server. If the error is not cleared after turning the
CE-01
power off and on, turn off the power and contact your dealer.
The scanned image was not sent because a connection to the server could not be established.
Make sure that the SMTP server settings or Scan to FTP destination settings in the Web page are
CE-02 correct.
CE-04 The procedure for configuring the SMTP server is explained in "Configuring SMTP, DNS and LDAP
server settings", and the procedure for editing Scan to FTP destination information is explained in
"Editing and deleting programmed transmission destinations".
The scanned image was not sent because the server was busy or there was too much traffic on line.
CE-03
Wait briefly and then try again.
The scanned image was not sent because the directory of the destination FTP server was not
CE-05
correct. Make sure that the correct FTP server information is configured in the Web page.
Scan data cannot be sent as E-mail address that is stored in the Destination List is not adequate.
CE-06
Check if the stored destination information is correct.
The size of the scanned image file exceeds the limit set in "Maximum Size of E-mail attachments" in
the Web page. Reduce the number of original pages scanned into the file, or change the limit set in
CE-09 "Maximum Size of E-mail attachments". Or it may exceed the limit of the file size at the mail server.
Reduce the volume of the original, otherwise change the resolution or the color mode to make the
scanned file size smaller.
The memory became full during scanning. Scan less pages, lower the resolution, or change the
CE-11
color mode so that the file size is smaller, and try scanning again.
It is time for regular maintenance. Contact your SHARP Service Department.
Maintenance required soon. Contact your SHARP Service Department.
Turn off the power and then turn it back on. If this does not clear the message, write
down the 2-digit main code and 2-digit sub-code ("
promptly contact your SHARP Service Department.
The toner cartridge must be replaced soon.
Check to see if the toner cartridge has been installed properly.
Replace the toner cartridge as explained in
CARTRIDGE (page 1-36).
The number of sheets in the output tray has reached the limit. Remove the paper.
The paper size specified for the tray is different from the actual size.
► LOADING PAPER (page 1-17)
Solution
6-12
Action
- "), turn off the power, and
REPLACEMENT OF TONER
Page
–
8-7
8-15
–
8-7
8-7
8-13
8-13