Energy Save; List Print - Sharp MX-B350W User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS

Energy Save

These settings are used to configure energy saving
settings. To access one of these settings, select "Energy
Save" in the mode selection screen, and select the
desired setting in the energy save screen, and then
press the [OK] key.
Auto Power Shut-Off
This setting is used to enable auto power shut-off mode,
which automatically turns off the power to the fusing unit
if the operation panel is not used for a certain duration of
time.
Enabling auto power shut-off mode helps conserve
energy, preserve natural resources, and reduce
environmental pollution.
The function is initially enabled.
Rather than disabling the auto power shut-off feature,
it is recommended that you first try lengthening the
time set in "Auto Power Shut-Off
In most cases a suitable timer setting will allow work to
proceed with minimal delay and still enable you to
enjoy the benefits of power conservation.
Auto Power Shut-Off Timer
This setting is used to set the duration of time until auto
power shut-off mode activates when the operation panel
is not used. Using this function helps conserve energy,
preserve natural resources, and reduce environmental
pollution.
"1 min.", "3 min.", "5 min.", "10 min.", "15 min.",
"30 min.", "45 min.", "60 min.", "75 min.", "90 min.", "105
min." or "120 min." can be selected for the duration of
time. Select a setting that suits your work conditions.
The factory default setting is 1 minute.
Preheat Mode
This setting is used to set the duration of time until
preheat mode, which automatically lowers the fusing unit
temperature, activates when the operation panel is not
used. Using this function helps conserve energy,
preserve natural resources, and reduce environmental
pollution. "1 min.", "3 min.", "5 min.", "10 min.", "15 min.",
"30 min.", "45 min.", "60 min.", "75 min.", "90 min.", "105
min." or "120 min." can be selected for the duration of
time. Select a setting that suits your work conditions.
The factory default setting is 1 minute.
Timer" (see below).
7-15
Enter Auto Power Shut-Off after
the Remote Job
This function works in Auto Power Shut-Off mode. When
the machine completes a print job received from the PC
or outputs received fax data, the machine immediately
returns to the Auto Power Shut-Off mode.
Toner Save Mode (Copy)
Toner Save Mode (Print)
You can reduce the amount of toner used for
copying/printing.
Toner Save Mode (Print) is only effective when the
machine's printer driver is not used. When the printer
driver is used, the printer driver setting takes
precedence.
This function may not operate in some applications
and operating systems.

List Print

This is used to print lists and reports that are only for use
by the administrator of the machine.
Select [List Print] to choose the list and the report you
want to print.
Fax Settings Shows the current state of the system
settings, as well as the sender name,
sender number, polling passcode
numbers, and forwarding numbers.
Inbound Shows the inbound routing settings for
Routing routing received faxes on your network.
User Usage List Shows the communication time and
number of pages transmitted by each user.
Activity Report Shows a log of past communication
performed on the machine (date of
communication, name of other party, time
required, result, etc.).
Junk Fax # List Shows the stored fax numbers from which
reception in
blocked.
User Info. Print The user name, user number, paper used,
paper limits, and function permission
settings can be printed for each user.
Anti Junk Fax (page 7-22) is