Transmission By Auto-Dialing (One-Touch Dialing And Group Dialing); Sending A Fax By Speed Dialing - Sharp MX-M350N Facsimile Operation Manual

SENDING A FAX
TRANSMISSION BY AUTO-DIALING
(ONE-TOUCH DIALING AND GROUP DIALING)
Fax numbers can also be dialed by automatic dialing (one-touch dialing and group dialing). Follow the steps below
to send a fax using an auto dial number. To use an auto dial number, the name and fax number of the destination
must first be stored. For information on auto dial numbers, see page 1-12. To store an auto dial number, see pages
6-3 and 6-6.
1 Perform steps 1 through 6 of "BASIC
PROCEDURE FOR SENDING FAXES"
(page 2-2).
2 Touch the [ADDRESS BOOK] key.
PEAKER RESEND
FAX
ADDRESS BOOK
SWITCH
ADDRESS REVIEW

SENDING A FAX BY SPEED DIALING

In addition to one-touch dialing and group dialing, you can also send a fax by touching the
and entering a 3-digit Speed Dial number. Follow the steps below to send a fax by Speed Dialing. The 3-digit Speed
Dial number is automatically assigned by the machine when a one-touch key or group key is stored. (See Speed Dial
numbers on pages 6-3 and 6-6.)
1 Perform steps 1 through 6 of "BASIC
PROCEDURE FOR SENDING FAXES"
(page 2-2).
2 Touch the key (Speed Dial key).
SPEAKER
FAX
MODE SWITCH
2-4
The address book
screen appears.
This step is not
necessary if the address
book already appears.
Go to step 3.
3 Touch the one-touch key for the desired
destination.
READY TO SEND.
SHARP CORPORATION CORPO.TPS
SHARP GROUP
FREQUENT USE ABCD EFGHI JKLMN OPQRS
selection. The key display will return to normal.
4 Continue from
PROCEDURE FOR SENDING FAXES"
(page 2-3).
3 Enter the 3-digit Speed Dial number.
Speed Dial numbers on pages 6-3 and 6-6.)
Zeros at the beginning of the number (such as
001) can be omitted. Touch the
Dial key).
If you enter the wrong number, press the [C] key to
clear it. If you enter a 3-digit number that is not
stored in the machine, press the [C] and then enter
the correct number. If you do not know the 3-digit
number, print the stored destination list (See
"PRINTING PROGRAMMED INFORMATION" on
page 6-16.)
4 Continue from
PROCEDURE FOR SENDING FAXES"
(page 2-3).
Refer to page 1-5 for
S
information on using the
address book screen.
The key you touched is
highlighted. If you touch
the wrong key, touch the
key again to cancel the
step 8 of "BASIC
key (Speed Dial key)
Enter the 3-digit Speed
Dial number that was
automatically assigned
by the machine when
the destination was
stored in a one-touch
key or a group key. (See
key (Speed
step 8 of "BASIC