Sharp MX-B350W User Manual page 140

FACSIMILE►BASIC TRANSMISSION METHODS
Transmission settings (memory transmission mode and direct
transmission mode)
Transmission modes include memory transmission, where the original is temporarily scanned into memory before
transmission, and direct transmission, where the original is transmitted directly without being scanned into memory.
There are two types of memory transmission:
pages of the original are scanned into memory before transmission begins, and
destination is dialed after the first page is scanned and the remaining pages are transmitted as they are scanned.
During a memory transmission, it may happen that the memory becomes full while the originals are being scanned.
See If the memory becomes full during transmission of a stored transmission job (page
becomes full during a quick online transmission (page 4-17)
If there are too many pages and memory transmission is not possible, you can press the [COMM. SETTING] key to
switch from memory transmission to direct transmission. When direct transmission is used, transmission begins after the
current job is completed, allowing you to give priority to a transmission job. As such, direct transmission is a convenient
means of performing an interrupt transmission when there are a large number of stored transmission jobs.
To switch between memory transmission and direct transmission, see the following
When transmission is performed manually using an extension phone connected to the machine or using on-hook dialing,
direct transmission is automatically selected. (Memory transmission is not possible.)
Faxing by direct transmission
Press the [COMM.SETTING] key
1
The communication settings screen appears.
2
The communication settings screen can also be displayed from the function selection screen.
Press the [SPECIAL FUNCTION] key to display the special function selection screen, select "Comm. Setting" with the
[ ] or [ ] key, and press the [OK] key.
3
Dial the fax number and press the [START] key.
4
When using the document glass, multiple original pages cannot be transmitted in a single transmission.
• To change from "Direct Transmission" back to "Memory Transmission", select "Memory TX" in step 3.
• To cancel a direct transmission, press the [C] key.
Storing transmission jobs (memory transmission) (page
.
Select "TX" with the [ ] or [ ] key.
Select "Direct TX" with the [ ] or [ ] key and press the
[OK] key.
4-15
4-17), where all
Quick On-line (page 4-17), where the
4-17), and see If the memory
"Faxing by direct transmission".