SMART Board SBID-MX165 Installation And Maintenance Manual page 42

CHAPTER 4
CONFIGURING THE DISPLAY
3. Insert the USB drive into the display USB.
4. Press Menu on the front control panel to open the e³ experience system software
settings.
5. Tap Update.
6. Tap Check.
A dialog box appears.
7. Tap USB.
8. The upgrading software screen appears.
If the update includes an upgrade to the touch firmware, don't touch the screen during an
update.
9. Using the switch on the back of the display, turn off the display.
10. Wait 10 seconds.
11. Using the switch on the back of the display, turn on the display.
34 smarttech.com/kb/171288