Installing Your Blackfly S - FLIR BLACKFLY S USB Vision Installation Manual

3.3 Installing Your Blackfly S
1. Install the Tripod Mounting Bracket (optional)
2. Attach a Lens
Unscrew the dust cap from the lens holder to install a lens.
3. Connect the interface Card and Cable to the Camera
When the camera is first connected, the operating system automatically installs the camera driver. Camera
drivers are available with the Spinnaker SDK installation.
a. If using PoE, connect a powered Ethernet switch or Ethernet power injector in between the card and the
camera.
4. Plug in the GPIO connector if required
5. Confirm Successful Installation
Run the SpinView application: Start->All Programs-> Point Grey Spinnaker->SpinView
The SpinView application can be used to test the camera's image acquisition capabilities.
Changes to your camera's installation configuration can be made using the SpinView application.
5/4/2017
©2015-2017 FLIR
Integrated Imaging
Solutions Inc.
All rights reserved.
The ASA and ISO-compliant tripod mounting bracket attaches to the camera using the
included screws.
GPIO can be used for power, trigger, and strobe.
FLIR Blackfly
Plug the interface cable into the host controller card and
the camera. The cable jack screws can be used for a
secure connection.
®
S Installation Guide
3 Blackfly S Installation
6