Table Of Contents - FLIR BLACKFLY S USB Vision Installation Manual

Table of Contents

1 Blackfly S Installation Guide
2 Handling Precautions and Camera Care
3 Blackfly S Installation
3.1 Preparing for Installation
3.2 Installing Your Interface Card and Software
3.3 Installing Your Blackfly S
3.4 Powering Your Blackfly S
4 Tools to Control the Blackfly S
4.1 Using the Spinnaker® Software Development Kit
4.1.1 SpinView Camera Evaluation Application
4.1.2 Custom Applications Built with the Spinnaker API
4.2 Using GenICam Applications
5 Configuring Blackfly S Setup
5.1 Configuring Camera Drivers
5.2 Configuring the IP Address-GigE only
5.3 Allocating Bandwidth-GigE only
5.3.1 Determining Bandwidth Requirements
5.4 Configuring Other Ethernet Settings-GigE only
5.4.1 Stream Channel Destination Address
5.4.2 Heartbeat
5.5 Camera Firmware
5.5.1 Determining Firmware Version
5.5.2 Upgrading Camera Firmware
6 Blackfly S Physical Interface
6.1 Blackfly S Physical Description
6.2 Blackfly S Dimensions
6.3 Interface Connector
6.3.1 Ethernet Connector
6.3.2 USB 3.1 Connector
6.4 Interface Cables
6.5 Interface Card
6.6 General Purpose Input/Output (GPIO)
5/4/2017
©2015-2017 FLIR
Integrated Imaging
Solutions Inc.
All rights reserved.
®
FLIR Blackfly S Installation Guide
1
2
3
3
4
6
7
8
8
8
8
9
11
11
11
12
12
13
13
13
15
15
15
16
16
17
19
19
19
20
20
21
i