Network Analyzer Operation - Keysight 85024A User's And Service Manual

Network Analyzer Operation

This section provides some general information for performing basic network
analyzer operations. For more specific operating information, refer to your
analyzers user's guide.
Presetting the network analyzer
All analyzers have a [PRESET] hardkey for this function.
Selecting a transmission (or S21 measurement)
871x family
8753 family
Setting the frequency range
871x family
8753 family
Setting CW mode for power meter measurements
871x family
8753 family
Keysight 85024A User's and Service Guide
Press [MEAS 1], then Transmission or Fwd Trans S21.
Press [Chan 1] or [CH 1], then [Meas] followed by
Transmission or TRANS:FWD.
Start and stop frequencies are accessed via [FREQ].
Start and stop frequencies are accessed via [Start] and
[Stop].
Press [FREQ] CW, then [MENU] and set the Trigger mode to
Hold. To return to normal operation, set the trigger mode to
Continuous and define start and stop frequencies.
Press [Menu] or [Sweep Setup] to access both the sweep and
trigger functions. The CW FREQ softkey activates CW mode,
press TRIGGER MENU then HOLD. To return to normal
operation, change the trigger mode to CONTINUOUS, [Menu]
or [Sweep Setup], then SWEEP TYPE MENU followed by
LIN FREQ.
Performance Tests 5
39