Keysight 85024A User's And Service Manual page 72

7 Service
19 Place the spring clip over the conductive strip, flush with the front of the
Refer to
20 Replace the nose assembly and nut.
Figure 7-10 Special spanner/wrench tool and area of use
72
heatsink. The beveled end of the clip should face away from the front of the
wand. The center of this U-shaped clip must press into the elastic conductor.
Insert one side of the clip into the small slot in the probe heatsink. Press the
other side of the clip down with the small screwdriver until it snaps into the
other slot.
Figure 7-6.
Keysight 85024A User's and Service Guide