Failure to remove the nose assembly prior to replacing the tip will result in
CAUTION
damage to the conductive elastomer on the tip assembly.
Figure 7-7
Removing the plastic regulator housing covers
Tools required:
– 1/8 inch-wide flatblade screwdriver
In the steps below, hold the regulator housing and screwdriver so that you
WARNING
won't injure yourself if the screwdriver slips.
Refer to
1 Hold the regulator assembly by one end and insert the head of a 1/8 inch-wide
Keysight 85024A User's and Service Guide
Probe wand components
Figure
7-8.
flatblade screwdriver into the seam at the other end. The seam separates the
two halves of the housing cover. Twist the screwdriver 90°.
Service
7
67