Teledyne D series Installation And Operation Manual page 65

Figure 2-14 Secure screws with the
Section 2 Fluid System Connections and Accessories
3. Run the pump until the display shows C
Note
This will fill the pump with air to prevent spills later.
4. Toggle the S
TANDBY
the controller display.
5. Toggle the P
OWER
pump.
6. Unplug the pump from the M
7. Disconnect the transducer connector from the top of the
transducer (Figure 2-13) and position the cable out of the
way.
8. Place the two parts of the C
Wrench Kit 60-1249-132) onto the pump cylinder just
below the threads for the cylinder cap (approximately 1/4"
(6 mm) below the cylinder cap) (Figure 2-14).
Cap screws
Hex wrench
1
/ " hex wrench
4
Note
If your pump has a cooling jacket installed, assemble the
C H below the cooling jacket.
YLINDER OLDER
9. Install the 5/16-18 X 1" Cap Screws (supplied with the
Wrench Kit) to hold the two parts of the C
H in place (Figure 2-14).
OLDER
10.Tighten the cap screws referred to in step 9 above with
1
the / " hex wrench (supplied with the Wrench Kit) as
4
shown in Figure 2-14, securing the C
the pump cylinder.
11.Using the two wrenches (supplied with the Wrench Kit)
remove the cylinder cap assembly (Figure 2-15).
D Series Syringe Pumps
YLINDER
switch on the controller, turning off
switch on the pump to turn off the
power.
AINS
H
YLINDER OLDER
Cylinder holder
YLINDER
F .
ULL
(part of
YLINDER
H to
OLDER
2-15