Controls And Indicators; Pump Controller Front Panel Label - Teledyne D series Installation And Operation Manual

D Series Syringe Pumps
Section 1 Introduction
1.4 Controls and
Indicators
1
Figure 1-5 Pump controller key functions
Item No. on Connector
Figure 1-5
1 On/Standby switch
2 Programming keypad
3 Softkeys
4 Liquid crystal display
1-14
The pump controller regulates all pumping functions. It is
designed to sit on top of the pump base, but may be located else-
where, according to safety and convenience. Programming and
setup are performed using the keypad on the front panel. The
controller front panel is shown in Figure 1-5 and described in
Table 1-10. Table 1-11 explains the key functions.
The rear panel of the pump controller contains several input and
output connectors, explained in Table 1-12, and shown in
Figure 1-6.
The only operational control on the pump itself is the power
switch, shown in Figure 1-8. The rear panel has several con-
nectors, described in Table 1-13, and shown in Figure 1-7.
3
Table 1-10 Pump Controller Front Panel Label
4
2
Description
Turns instrument off and on.
(Does not disconnect power.)
Used to program controller.
Labeled A, B, C, and D; used to select menu items
displayed directly above them.

40 Characters 4 line.