Outlet Connections - Teledyne D series Installation And Operation Manual

4.2.2 Outlet Connections

Figure 4-2 Pump outlet connections
Section 4 Gradient Pumping for Pressure, Flow, and Concentration Modes
Kit components and connections are shown in Figure 4-2.
1. Mount the two-way outlet valve on the side of the pump
housing opposite the refill valve, with the spacer block and
screws provided.
2. Connect the pre-bent SST tubing between one port of the
valve and the pump outlet. Use the nut and ferrule to con-
nect the tubing at the outlet and the valve fittings to con-
nect the tubing at the valve.
3. Connect the 5.1 cm length of
the valve, using the valve fittings.
4. Connect the
5. Connect the
length of
priate length.)
spacer block

1
8
1 
" side of the reducing union to the tubing.
8
1 
" side of the reducing union to the 1.5 m
16
1 
" tubing. (This tubing may be cut to an appro-
16
FROM REFILL
KIT ASSEMBLY
2-way
valve
TO
APPARATUS
D Series Syringe Pumps
" tubing to the other port of
pre-bent
SST tubing
SST tubing
4-5