To Run Or Stop; Tips For Running Continuous Flow - Teledyne D series Installation And Operation Manual

5.6.5 To Run or Stop

Figure 5-13 Keystrokes to Run or Stop the pumps
5.6.6 Tips for Running
Continuous Flow
Section 5 Continuous Flow Introduction, Installation, & Operation
This menu setting allows the operator to run or stop both pairs of
pumps simultaneous.
( )
MORE
( -P )
MULTI UMP
(F P
OUR UMP
R /S )
UN TOP
Note
Before pressing
RUN
on the screen, and that the set flow rate/pressure is correct.
Always verify the valve settings before running a program. If a
controller is reset or moved to a different power source, it will
revert back to default settings (Active).
Liquids Checklist:
1. Degas liquids if appropriate.
2. Purge air from the system:
a. Fill both pumps completely by pressing
selecting each pump to fill.
b. Route the outlet to waste or reservoir and press
Press
STOP
c. Open the valves to atmosphere by pressing
then selecting each valve to open.
d. Zero the pressure in each pump by pressing
and selecting each pump to zero.
e. Connect the outlet tubing and fill each pump once
more.
3. Reset total volume (see Figure 5-9).
D Series Syringe Pumps
(P )
REVIOUS
Press 3x to return
to run screen
, ensure that
ON CONT FLOW
when fluid comes out of the outlet.
is displayed
and
REFILL
.
RUN
,
ACC CTRL
ZERO PRESS
5-21