Inlet Tubing - Teledyne D series Installation And Operation Manual

5.2.3 Inlet Tubing

Section 5 Continuous Flow Introduction, Installation, & Operation

1
" nuts and ferrules to attach to the double check valve
8
housings.
4. Attach the inlet tubing assembly. The tubing you use
depends upon whether or not your source is pressurized.
a. Pressurized Reservoir:
Connect the
bottom of the inlet tee, using high pressure valve fit-
tings.
Note
The filter and PTFE tubing are not used.
b. Nonpressurized Reservoir:
Connect the
each inlet check valve using the ferrule and nut with
support spring provided in the package. Attach the tub-
ing to the filter connector and then connect the filter.
Note
The stainless steel tubing is not used.
5. Once the contents of the continuous flow package are
totally assembled, attach the connectors appropriate for
your pump on one side of the assembly to a port. Then, sup-
porting the tee/valve assembly attach the other connector
to the port of the second pump.
6. Attach the outlet fittings to the top of the upper tee. Fit-

1
tings for " tubing, as well as an optional reducing fitting
8
1 
for " tubing, are provided. Use the fittings appropriate
16
for your tubing size.
7. Tighten all fittings.
There are two types of inlet tubing provided with this kit. The
stainless steel tubing is to be used for a pressurized inlet source,
the PTFE tubing may be used if the source is not pressurized.
RISK OF INJURY. THE PRESSURE PRODUCED
COULD BE 700 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND CONNECTIONS
NOTED IN THE MANUAL.
Note
The fittings for connection to pressurized source are not pro-
vided. A CO cylinder connection package (P/N 68-1247-043)
2
is available. Refer to section 2A.3.2 of the Instruction Manual.
D Series Syringe Pumps
1  "  1.5 m stainless steel tubing to the
8
1  "  1.5 m PTFE tubing to the bottom of
8
DANGER
5-3