Pump Rear Panel Connectors - Teledyne D series Installation And Operation Manual

8 4-20mA OUTPUT
ANALOG OUTPUT
ELECTRIC VALVES
12-CH OUTPUT
9 DIGITAL I/O
ANALOG OUTPUT
10 SERIAL TAG
11 CHASSIS GROUND
a. Connectors based on installed optional circuit board configuration.
Figure 1-7 Pump rear panel connectors
Item No. on Connector
Figure 1-7
1 Pressure outputs
2 Ground
3 Pressure transducer
4 Control cable
5 Mains
a
Optional circuit provides 4-20mA current loop output and additional digital
inputs and outputs.
a
Optional circuit provides flow rate and volume outputs. See Section 3.9.
a
Optional circuit provides motor drive for valve operation.
a
Additional circuit provides flow rate, pressure, and volume outputs.
a
Optional circuit provides additional digital inputs and outputs.
a
Optional circuit provides flow rate and volume outputs. See Section 3.9.
This tag indicates the serial number of the instrument.
Ground point for high static or remote controller installations.
60-1242-306
Table 1-13 Pump Rear Panel Connectors
Description
Two red binding post/banana jacks providing pressure output voltages.
Pump
65D
30D
All others
A black binding post/banana jack providing a connection to circuit
common.
The pressure transducer cable must be plugged in for the pump
to operate.
This cable connects the pump to the controller.
IEC power connector with EMI filter.
Left Jack Right Jack
VDC/psi VDC/psi
1.0 V/2000 psi 0.1 V/2000 psi
1.0 V/3000 psi 0.1 V/3000 psi
1.0 V/1000 psi 0.1 V/1000 psi
D Series Syringe Pumps
Section 1 Introduction
1-17