Installation; Rear Jacks - Lippert Components Level Up Installation And Owner's Manual

4. Drop the underbelly from the outside edge of the
trailer. Start on the side closest to where the pump will be
located and un-bolt the underbelly from the front of the
trailer to approximately 2 feet beyond the rear tire. On the
opposite side of the trailer, un-bolt the underbelly from
approximately 2 feet behind the rear tire to approximately
2 feet in front of the front tire. Do not remove any bolts
from the center of the underbelly. Do not drop the entire
underbelly. Attaching and aligning the entire underbelly will
be more difficult than working around the underbelly.
5. Locate and move any wires, hoses, etc. that could be
damaged while welding the jack brackets to the frame.
Check both inside and outside of the frame. Shields made
of metal or wood can be used to push wires and hoses
away from the frame area where welding is to be done.
6. Bolt the footpads to the jacks and torque to 132 ft-lb.
Make sure to use Loctite™ 263 High Strength Thread
Locker (Red) on the footpad bolts. See bolt in (Fig.2)
assembly for reference.
NOTE: Do not try to remove the bolt once it is tightened.
Removing the bolt could result in damage to the cylinder.

Installation

Rear Jacks

1. When fully retracted, the rear jacks MUST be mounted
to achieve a minimum ground clearance equal to the
departure angle (Fig.1) or no less than 8" to the ground to
enable maximum level correction. Any additional ground
clearance added to the jack location will decrease the
amount of level correction available to the system.
2. Bolt the leveling jacks to the mounting brackets to
achieve proper ground clearance. Make sure the bolts are
tightened to 52-64 ft-lbs (Fig.3).
3. Identify power unit mounting location. This will determine
the orientation of the hydraulic fittings. If the power unit
is, or will be, mounted on the driver's side of the front
compartment, the driver's side front leveling jack will be the
first jack in the system.
lci1.com 574-537-8900
Level Up
Installation and Owner's Manual
(For Aftermarket Application)
Leveling Jack
O-Ring
O-Ring
Washer
Bolt
Fig.2
3
CCD-0001533
™
Foot Pad
Fig.3
Rev: 06.29.18