Wiring The System; Lcd Touch Pad - Lippert Components Level Up Installation And Owner's Manual

5. Connect the retract hose to the retract (UP) side of the
power unit, and then to the JIC fitting on the retract valve
block closest to the power unit, (Fig.20J).
6. Make hoses to connect the valve blocks to the lead
landing gear. Six-foot lengths should be sufficient; one (1)
extend (orange) hose and one (1) retract (black) hose.
7. Connect the extend hose to the final JIC fitting on the
extend valve block, (Fig.20I) to the JIC fitting directly
across from the cartridge valve and coil assembly that is
installed on the lead landing gear, (Fig.21A).
8. Connect the retract hose to the final JIC fitting on the
retract valve block (Fig.20L) to the JIC fitting in the retract
port on the lead landing gear (Fig.21D).
9. Make hoses to connect the lead landing gear to the
follow landing gear. Nine-foot lengths should be sufficient:
one (1) extend (orange) hose, and one (1) retract (black)
hose.
10. Connect the extend hose to the JIC fitting in the rear of
the lead landing gear (Fig.21B) and then to the JIC adapter
in the extend port of the follow landing gear.
11. Connect the retract hose to the JIC fitting in the other
retract port of the lead landing gear (Fig.21E) and then to
the fitting in the retract port of the follow landing gear.
B
Fig.21
lci1.com 574-537-8900
C E
A
D
Level Up
Installation and Owner's Manual
(For Aftermarket Application)

Wiring the System

NOTE: Refer to the wiring diagram throughout this section.
NOTE: The Level Up system wiring is basically a plug and
play system. Your kit should include harnesses for the
entire system. If it does not, contact Lippert Components to
have the proper harnesses shipped to you.
1. Install the controller to the ceiling of the front
compartment. It must be centered side to side, and
oriented according to the arrows on the controller label.
2. Connect the rear sensor harness to the matching port
on the controller.
NOTE: Each connector on the controller is a different
shape and has a different number of pins. Each harness
that connects to the controller can only be connected in
one specific way. This prevents the installation of the wrong
harness in the wrong connector.

LCD Touch Pad

1. Determine where to mount the touch pad. The touch pad
should be mounted in a compartment on the side of the
unit so the operator will have a view of the hitch pin while
using the touch pad.
2. Remove the face plate of the touch pad from the
mounting bezel (Fig.22).
Fig.22
8
CCD-0001533
™
Rev: 06.29.18