Label Sensing - SATO M10e Operator's Manual

LABEL SENSING

The M10e can position labels using either a label gap (transmissive) or an Eye-Mark
(reflective) sensor. The sensor used is selected by DSW2-2. The sensor position are fixed and
cannot be adjusted. In addition, the signals from the sensors can be adjusted using the LCD
panel to compensate for different liner opacities and/or Eye-Mark reflectance values.
Cut Position
SATO M10e
Print Position
Platen Roller
Auto Load Sensor
Auto Load Sensor
Label Gap Sensor
Paper End Sensor
All dimensions are in mm
PN 9001101 Rev. A
Feed Roller
Label Sensor
Eye Mark Sensor
Label Feed Direction
Section 2. Installation
Page 2-7