Label Sensing - SATO CT400 Operator And Technical Reference Manual

LABEL SENSING

The CT Series printers can use either label Gap (see-thru) or Eye-Mark (reflective)
sensing. The Sensor Assembly is located on the left edge of the media and is
automatically positioned by the Paper Guides.
The printer is shipped from the factory with the default sensing method set for label
gap. The setting can be overridden by using the <ESC>IG command (Section 4)
however it will be reset to the default when power is cycled. The default setting can
be changed using the <ESC>PG command (Section 4) or the Printer Configuration
Utility program on the CD-ROM.
Backing
Paper Inside
Edge
Page 2-10
Miminum Eye-Mark Size
.12 in (3 mm) W x .5 in. (12 mm) L
0.20" (5 mm) Eye-Mark Sensor
0.25" (6.3 mm) Gap Sensor
Label Inside Edge
CT Series Printer Label Sensor Positioning
Eye-Mark
Roll Paper
9001069A
Section 2. Installation and Configuration
Inter-Label Gap
Min. 0.12" (3 mm)
Max. 0.20" (5 mm)
Eye-Mark
Fanfold Paper
SATO CT Series Printers
Label
Feed
Direction