SATO M10e Operator's Manual page 46

Section 3. Configuration
SELECT LANGUAGE
ENGLISH
IGNORE CAN/DLE
YES
PRIORITY SETTING
COMMAND
LABEL RE-DETECT
ENABLE
IEEE1284
ACK SIGNAL
SERVICE MODE
Page 3-24
This selection allows the user to select the character set used by
the printer. The selections are English, French, German,
Spanish, Italian and Portuguese.
1. Press the Cursor keys to advance to the desired languarge
setting.
2. When the setting is correct, press the ENTER key to accept
the setting and step to the next display.
If the printer is placed in the Multi-Item Buffer Mode (DSW2-5 =
NO OFF), the user can chose to ignore CAN (18H) and DLE (10H)
commands used in bi-directional communications (see Section
6: Interface Specifications). If the Single Item Buffer Mode is
chosen (DSW2-5 = ON), this display will be skipped.
This selection allows the user to assign a priority for Print
LCD Darkenss, Print Speed and Print Offset setting methods. If LCD
is selected, the setting established via the LCD display/menu
system will be used for an incoming label job, regardless of any
different command settings. If Command is selected, any
commands in the label job will take precedence and be used for
printing the job.
1. Use the Cursor keys to step to the desired priority.
Once the desired setting is selected, press the ENTER key to
accept the setting and step to the next display.
This selection allows the user to disable the feeding of a blank
DISABLE
label upon power up. If Enable is selected, the printer will
automatically feed a label until it detects a label enge. This will
correctly position the next printed label under the print head. If
Disable is selected, the printer will not try to detect the next label
and the operator is responsible for ensuring that the label is
correctly positioned before printing.
1. Use the Cursor keys to step to the desired setting.
Once the desired setting is selected, press the ENTER key to
accept the setting and step to the next display.
If the printer is placed in the Single Item Buffer Mode (DSW2-5 =
00.5
ON), this selection allows the user to set the width of the
IEEE1284 ACK pulse. In the Multi-Item Buffer Mode, this display
will be skipped.The range is 0.5 µsec to 10 µsec.
1. Use the Cursor keys to step the display to the desired
setting. The setting will advance in increments of 0.1 µsec
each time the LINE key is pressed until the setting reaches
10.0 µsec when it will wrap around to the 0.5 µsec setting.
Once the desired setting is selected, press the ENTER key to
accept the setting and step to the next display.
The Service mode is exited by powering the printer off and then
back on.
PN 9001101 Rev. A SATO M10e