SATO M10e Operator's Manual page 34

Section 3. Configuration
PITCH OFFSET
+ 00mm
Page 3-12
The label Pitch is the distance from the leading edge (the edge
that comes out of the printer first) of a label and the leading edge
of the next label. The leading edge position of the label can be
adjusted relative to the print head +/- 59mm in increments of
1mm. Once the position is set, it can be fine adjusted +/-
3.75mm using the PITCH potentometer on the Adjustment
Panel.
1. The cursor will initially be positioned over the Pitch Direction
setting. Use the Cursor keys to step to the positive (+) or
negative (-) selection. A positive selection moves the
leading edge of the label forward (away from the print head)
while a negative selection moves the leading edge of the
label back into the mechanism.
2. Once the correct direction is selected, pressing the ENTER
key will accept the setting and advance the cursor to the
Offset selection.
3. Use the Cursor keys to step the first digit of the counter to
the desired setting. The display will increment one step each
time the Cursor keys are pressed. The maximum setting is
5.
4. Press the ENTER key to accept the setting and advance the
cursor to the second digit. Again use the Cursor keys to step
to the desired setting. Once it is correct, pressing the
ENTER key will step to the next adjustment.
5. You may wish to print a test label after completing the
adjustments to ensure they are correct.
PN 9001101 Rev. A SATO M10e