Default Settings; Switch Selections - SATO M10e Operator's Manual

DEFAULT SETTINGS

SWITCH SELECTIONS

All switches are placed in the Off default position for shipping. This will result in the
following operating configuration:
Communications:
Protocol:
Sensor:
Receive Buffer:
Mode:
Label Sensor:
Backfeed:
External Signals:
SOFTWARE DEFAULT SETTINGS
The printer stores the software settings upon receipt and uses them until they are again
changed by receipt of a command containing a new setting. These settings are stored in non-
volatile memory and are not affected by powering the printer off. The printer may be reset to
use the default software settings by depressing the LINE and FEED keys simultaneously while
powering the printer on. This will result in the following default configuration:
Once the default operation is completed, a DEFAULT COMPLETED message will be
displayed on the LCD panel. The printer should be powered off while this message is being
displayed (or after the beep is heard. This saves the default settings in the non-volatile memory
where they will be automatically loaded the next time the printer is powered on.
SATO M10e
8 data bits, no parity, 1 Stop bit, 9600 Baud
Ready/Busy
Gap Sensor
Multi Job
Batch/continuous
Sensor Used
Enabled
Enabled
Print Darkness
Print Speed
Print Reference
Zero
Auto On Line
Feed on Error
Feed Reprint
Priority
DEFAULT COMPLETED
PN 9001101 Rev. A
M10e
3
4 in. per sec.
Vertical = 0000, Horizontal = 0000
Slash
Enabled
Enabled
Enabled
Command
Section 3. Configuration
Page 3-7