SATO M10e Operator's Manual page 27

Label Sensor Selection (DSW3-3). Enables or disables the Label Sensor. If the Sensor is
enabled, it will detect the edge of the label and position it automatically. If it is disabled, the
positioning must be under software control using Line Feed commands.
DSW3-3
Off
On
Back-Feed Selection (DSW3-4). When Back-Feed is enabled, the printer will position the
last printed label for dispensing and retract it before printing the next label. The amount of
backfeed offset is adjustable.
DSW3-4
Off
On
External Signal Interface. See Section 6: Interface Specifications for information on the
External Signals.
EXT Print Start Signal Selection (DSW3-5). Allows an external device to initiate a label
print for synchronization with the applicator. When DSW3-5 is On, the unit is in the
Continuous print mode, Backfeed is disabled and External Signals are ignored.
DSW3-5
Off
On
SATO M10e
SETTING
Not Used
Sensor Used
SETTING
Disabled
Enabled
SETTING
Enabled
Disabled
PN 9001101 Rev. A
Section 3. Configuration
DSW3
ON
OFF
1 2 3 4
DSW3
ON
OFF
1 2 3 4
DSW3
ON
OFF
1 2 3 4
5 6 7 8
5 6 7 8
5 6 7 8
Page 3-5