SATO M10e Operator's Manual page 47

COUNTERS MODE
The Counters Mode is provided to allow the user to access the internal printer cousters.
ADVANCED MODE
COUNTERS MODE
COUNTERS
HD CUT
HEAD COUNTER
HEAD COUNT CLEAR
YES
COUNTERS MODE
TEST PRINT MODE
The Test Print Mode offers 4 different status labels for troubleshooting. If DSW3-5 is in the
OFF position, the Test Print cycle must be initiated with a Print Start signal on the EXT
connector You enter the Test Print Mode by pressing the FEED key while powering the printer
on..
V 05.00.03.00
INITIALIZING
SATO M10e
The Counter Mode is accessed from the Advanced Mode. Press
the Cursor keys to step to the Counter Mode.
Pressing the ENTER key will advance the display to the counter
selections.
The counters are identified in the display as:HD:Head Counter
LIFE (should be reset when print head is replaced)
HD: Head Counter
CUT: Cutter Counter
LIFE: Life Counter (cannot be reset)
1. Use the Cursor keys to step the cursor to the desired
counter, the Head (HD) counter or the LIFE counter. The
default position is the Head Counter. Use the Cursor keys to
advance the cursor to the desired selection.
2. Once the correct setting is selected, pressing the ENTER
0.5M key will display the current value (in meters) stored in the
counter. The maximum number of digits displayed is 8.
3. Pressing the ENTER key again will advance the counter to
the Clear mode. All counters with the exception of the LIFE
counter may be cleared.
4. Use the Cursor keys to select the desired setting. If you only
NO wanted to read the counter value, select NO. If you want to
read the counter and reset it to 0.0, place the cursor over the
YES. Once the desired setting is selected, pressing the
ENTER key will advance the return you to the Counters
Mode display.
5. To exit the Counters Mode, turn power to the printer off and
then back on.
Displays the firmware during the initialization.
PN 9001101 Rev. A
Section 3. Configuration
Page 3-25