Advanced Setup Options; The Help Menu - GE Druck DPI 620-IS User Manual

Menu to upgrade the
DPI 620-IS software and
firmware
1
2
TAP

2.10.2 Advanced Setup options

2.11 The Help menu

[EN] English - K0460
To use the most up-to-date software and firmware on the
DPI 620-IS calibrator, visit the GE website:
www.gesensinginspection.com
Follow the website instructions, use this menu to upgrade:
•
Connect the instrument to be upgraded to a PC. Copy the
files to the instrument's storage memory (make sure the
instrument is in storage mode).
Note: Make sure the battery is fully-charged before starting the
upgrade process.
FILES
Use this menu to save and recall personal settings, instrument
calibration settings and other standard instrument operations.
Save: After setting up the functions needed on the display
(Section 2.8.3) and all the measure and source operations
(Section 2.9), save the settings to a file.
Recall: To use the specified settings again, select the
applicable filename from the list.
Erase One File: This deletes one file from the list. Confirm the
file to delete.
Clear User Settings: This clears user settings, they are
replaced by default (factory) settings.
Memory Status: The amount of memory available (in MB and
as a % of the total on the device): internal memory; SD card.
The Help menu includes electrical connection diagrams to help
set-up and use the electrical functions on channel 1 (CH1),
channel 2 (CH2).
Issue 1
Prepare the instrument 2-19