Edid Management; Auto Edid Mode; Using Custom Edid Data - ZeeVee ZyPer User Manual

By default, Auto EDID mode is enabled. This means that the Management Platform will
compare the encoder EDID with the decoder EDID. If they are different, then the EDID
from the decoder (sink) will be used by the encoder (source). Setting the EDID Mode
affects all join modes: fast-switched, genlocked, and video-wall. Refer to the
command in the API Command Listing (page 61)
HD Source
There may be some instances where a custom EDID is desired. One example is when
using a single encoder with multiple displays, such as a video wall. In such a case, follow
the steps below to save and load a custom EDID to the Management Platform.
1. Telnet to the Management Platform.
zyper@zyper:~$ telnet 192.168.1.6
2. Disable Auto EDID mode by entering the following command:
zyper$ set server auto-edid-mode disabled

EDID Management

Auto EDID Mode

Encoder
Zyper
Management
Platform

Using Custom EDID Data

section for more information.
Decoder
56
Advanced Operation
join
Display/Projector
EDID Data A/V Data