ZeeVee ZyPer User Manual page 130

Example
show device config USA4K since 20
device(d8:80:39:9a:e6:d);
device.gen; model=Zyper4K, type=encoder, name=USA4K, state=Up,
lastChangeId=12627
device.gen; firmware=3.1.3
device.gen; ethernet-management-port-mode=enabled
device.ports; video-port=hdmi
device.ip; mode=dhcp, address=172.16.6.33, mask=255.255.255.0,
gateway=172.16.6.1
device.rs232; sendingToMacOrIp=none(0.0.0.0), terminationChars=\
n\r, baudrate=57600, dataBit=8, stop_Bit=1, parity=none
device.ir; sendingToMacOrIp=none(0.0.0.0)
device.source; iconImageName=GenericVideoSource
, manufacturer=Unknown, model=Unknown, location=Unknown,
serialNumber=Unknown
device.audioOutSourceType; analogOutSourceType=none
device.sendIpMcastRange; first=224.1.1.1, last=224.1.3.255
device.videoStream; ipMcastAddr=224.1.1.7, mode=disabled,
datarate=0Mbps
device.videoScaledStream; ipMcastAddr=224.1.1.4, mode=enabled,
datarate=615Mbps
device.analogAudioIpMcast; ipAddr=224.1.1.9, mode=enabled
device.audioDownmixIpMcast; ipAddr=224.1.1.8, mode=disabled
lastChangeIdMax(132613);
Success
Related Commands
show device status
show device capabilities
show device connections
123
Advanced Operation