Nvdimm-N Battery; Removing The Nvdimm-N Battery - Dell EMC PowerEdge R840 Installation And Service Manual
Hide thumbs
Also See for PowerEdge R840:
- Technical manual (60 pages) ,
- Technical specifications (44 pages)
Table of Contents
Advertisement
Figure 24. Installing cooling fan
Next steps
1
Install the
non-GPU air shroud
2
Follow the procedure listed in
NVDIMM-N battery
The NVDIMM-N battery is installed on the air shroud.
Removing the NVDIMM-N battery
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
For GPU air shroud,
remove the GPU air shroud
CAUTION:
NVDIMM-N battery is not hot swappable. To prevent data loss and potential damage to your system, ensure that your
system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned off, by disconnecting the cables,
before removing the NVDIMM-N battery.
NOTE:
To avoid damage to the battery connector, hold the connector while installing or removing a battery.
Steps
1
Disconnect the cables from the NVDIMM-N battery.
2
Using Phillips #2 screwdriver, loosen the screw securing the NVDIMM-N battery to the air shroud.
3
Holding the blue touch point, lift the NVDIMM-N battery at an angle to disengage it from the slot on the air shroud.
or
GPU air
shroud.
After working inside your
system.
Safety
instructions.
Before working inside your
cover.
system.
Installing and removing system components
55
Advertisement
Table of Contents
