Setting Series Recording - Sanyo DSR-3709 Instruction Manual

3 RECORD SET

Setting series recording

Use the following procedure to perform series recording
when this digital video recorder is connected to other
digital video recorders.
If series recording is set and normal recording area or
alarm recording area remaining memory runs out,
recording can be continued on a another digital video
recorder. In doing so, recording to recording area with
remaining memory is stopped.
Connect multiple digital video recorders and use series
recording to record and save more video.
Connecting
1
Connecting series connection
terminals.
Connect the series output terminal of the first recorder to
the series input terminal of the second recorder, and from
the series output terminal of the second recorder to the
series input terminal of the third recorder and so on, in the
order that you want to record.
To setup an overwriting series connection, connect the
series output terminal of the last recorder to the series
input terminal of the first.
C
Use a connection cable less than 3 m in length.
For an overwriting series connection, when the last
digital video recorder runs out of memory, the first takes
over recording.
2
Connecting VIDEO terminals.
Connect camera to the VIDEO IN terminal of the first
recorder. Connect the VIDEO OUT terminal of the first
recorder to the VIDEO IN terminal of the second recorder.
Be sure to connect to the same channel. Connect to other
digital video recorders in the following order using the
VIDEO OUT terminal.
English
3
Connecting audio input terminals.
For audio recording, connect audio devices such as amps
and microphones to the various digital audio recorder
audio input terminals or microphone input terminals.
An audio device cannot be connected from the audio
output terminal on one digital video recorder to the
audio input terminal on the next as for video. Connect
devices to each recorder directly.
4
Connecting alarm input and external
timer input terminals.
For recording using external alarms or external timers,
connect a sensor or timer device to the digital video
recorder.
Connect to the external device with a cable, and connect
the first recorder to the second recorder with another
cable. Connect the cable from the first recorder to the
second recorder terminal and then from the second
recorder connect the cable to the third recorder and so on.
Settings
1
Set "OVERWRITE" for "NORMAL
RECORDING AREA" and "ALARM
C
RECORDING AREA" to "OFF".
2
Set "SERIES RECORDING" to "ON".
69
<RECORDING CONDITIONS SET>
NORMAL RECORDING AREA
OVERWRITE : OFF
ALARM RECORDING AREA
OVERWRITE : OFF
REMAINING DISK WARNING : 1%
SERIES REC : OFF
AUTO DELETE : OFF
<RECORDING CONDITIONS SET>
NORMAL RECORDING AREA
OVERWRITE : OFF
ALARM RECORDING AREA
OVERWRITE : OFF
REMAINING DISK WARNING : 1%
SERIES REC : ON
AUTO DELETE : OFF