Connecting Sanyo Protocol Devices (Dome Cameras); Connecting An Amplifier; Connecting Alarm In Terminals - Sanyo DSR-3709 Instruction Manual

3 INSTALLATION AND CONNECTIONS
Connecting SANYO protocol devices
(Dome Cameras)
Turn off all devices and use a coaxial cable to connect the
devices.
Use the same procedure to connect using PELCO and
BBV.
Camera
1
Connect cameras to the VIDEO IN
terminals.
2
Set the protocols and address in the
<CAMERA CONTROL SET> screen.
( P.97)
3
Operate the dome cameras with the
front panel buttons. ( P.99)
English

Connecting an amplifier

An amplifier is connected when using a microphone or
external speakers with the digital video recorder.
Audio input
Audio
output
AUDIO
IN OUT
IN OUT
Audio input from the AUDIO IN terminal and the MIC IN
terminal cannot be performed simultaneously. If both
terminals have devices connected, the MIC IN terminal
is used.

Connecting ALARM IN terminals

When using external alarms (i.e., intruder sensors and the
like), external switches are to be connected to the ALARM
IN terminals.
16
1
C 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
The DSR-3709 has nine ALARM IN terminals.
13
Amp
(sold separately)
Connecting ALARM IN
terminals to external
switches