Rear Panel - Sanyo DSR-3709 Instruction Manual

2 NAMES AND FUNCTIONS OF PARTS
DSR-3716
(The number of terminals for the DSR-3709 may differ. For more details, see below.)
1 2 3 4 5
1
IN
2
OUT
AUDIO
IN OUT
MIC IN
ALL
RESET
3 4 5 6

Rear panel

1. VIDEO IN terminals
The DSR-3709 has nine VIDEO IN terminals.
2. VIDEO OUT terminals
The DSR-3709 has nine VIDEO OUT terminals.
3. [ALL RESET] button
When the [ALL RESET] button is pressed, the digital video
recorder is reset and the time is returned to its default
setting.
4. AUDIO IN terminal
5. AUDIO OUT terminal
6. MIC IN terminal
7. MAIN MONITOR output terminal
8. MON2 output terminal
9. USB terminal
This terminal connects to a recordable CD-R/RW drive.
10. LAN terminal (10 Base-T or 100 Base-TX)
11. RS-485 termination switch
12. RS-485 terminal (A)
13. RS-485 terminal (B)
14. ALARM IN terminals
These terminals are used to activate alarm recording in
response to operation of an alarm switch on a connected
device.
The DSR-3709 has nine ALARM IN terminals.
Pin
C Ground
ALARM IN 1 to 16 Alarm input No. 1 through No. 16
15. SENSOR ALARM OUT terminals
The terminals are used when motion sensors have been
set ( P.81) to output an alarm signal to a connected
device upon detection of motion.
The DSR-3709 has nine SENSOR ALARM OUT terminals.
Pin
C Ground
SENSOR ALARM OUT Output of an alarm signal for Camera
1 to 16 No. 1 through No. 16
6 7 8 9 10 11 12
MONITOR OUT
MAIN MON2
USB LAN RS-485
TERMINATE
OFF
11 12
7 8 9 10
Signal
Signal
10
ALARM IN
C 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
13 14 15 16
C 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
REMOTE
A RS-485 B SENSOR
C R1 R2
ALARM OUT
ON
DO NOT CONNECT TO PHONE LINE
13
16. CONTROL terminals
Pin
C Ground
REMOTE R1 Remote input 1
REMOTE R2 Remote input 2
Input of a clock setting signal from an
CLOCK SET IN
external device
Output of a clock setting signal to an
CLOCK SET OUT
external device
ALARM OUT Total alarm output
ALARM RESET Alarm reset input
WARNING OUT Output of an HDD or FAN malfunction error
Capacity warning output for normal
FULL
recording area space
Capacity warning output for alarm recording
ALARM FULL
area space
Signal input from an analog series
SERIES IN
connection
SERIES OUT Signal output to an analog series connection
EXT TIMER IN Signal input from an external timer
NON REC OUT Non-recording output
C Ground
17. Power socket (AC IN)
Insert the supplied power cable securely into this socket.
18. Power cord holder
Secure the power cord to the holder
using the cord tie (accessory) as
shown in the illustration.
14 17
AC IN
18
C
CONTROL
16 15
Signal
English