Sanyo DSR-3709 Instruction Manual page 80

3 RECORD SET
7
Set "ALARM INTERLEAVE".
[Settings] ( indicates default setting)
Setting
Video is recorded only from cameras with an alarm
ONLY
occurring.
Recording is switched between camera video includ-
SW
ing an alarm and video from all connected cameras.
* Recording pattern for "SW" and "ONLY"
SW
Alarm
01 02 03 02 04 02
Alternate recording of multiple items of alarm video
ONLY
Alarm
01 02 03 02 02 02
Recording until the alarm is cancelled
8
Set "REC RATE" and "DURATION".
The maximum number of recording alarms (shown in
parentheses) changes in accordance with the new
settings.
(Default setting for recording rate: 15 FPS)
(Default setting for duration: 20 SEC)
Maximum number of
alarm recording
[Settings]
Item Setting
REC RATE 30 to 0.033 FPS
5 SEC, 10 SEC,
20 SEC, 40 SEC,
1 MIN, 2 MIN,
DURATION
3 MIN, 4 MIN,
5 MIN, 10 MIN,
15 MIN, CC
*1
Operates while an alarm is being triggered. (5 sec.
minimum)
English
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : ON
ALARM INTERLEAVE : ONLY
REC RATE: A 15FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: **** FPS, DURATION: ****
=> (01679 ALARMS CAN BE RECORDED)
ALARM TRIGGER : ALARM
MOTION SENSOR ->
Description
Alarm
05 04 06 02 07 04 08 02
Alarm is cancelled
02 02 04
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : ON
ALARM INTERLEAVE : ONLY
REC RATE: A 15FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: **** FPS, DURATION: ****
=> (01679 ALARMS CAN BE RECORDED)
ALARM TRIGGER : ALARM
MOTION SENSOR ->
Description
Sets the recording rate.
Sets the recording time per
alarm.
*1
When alarm recording settings have been
completed
9
Press the [EXIT/OSD] button.
EXIT/OSD
The setting procedure is ended and the display returns to
the normal screen.
"ALARM" and the number of alarms appear in the
operation display area.
When an alarm occurs, the alarm display flashes.
Number of alarm
Alarm display
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
If a new alarm occurs during alarm recording, the alarm
count is incremented in the same way as if two alarms
had occurred. However, in cases where alarms occur
consecutively on the same channel, alarm retrigger
settings ( P.84) can be used to ensure that these are
counted as one alarm only.
To set pre-alarm recording
Settings cannot be made for "PRE-ALARM
RECORDING" when "ALARM RECORDING" is set to
"OFF".
1
Turn the jog dial to select "PRE-ALARM
RECORDING", and then turn the shuttle
dial clockwise.
"OFF" flashes.
79
02
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : ON
ALARM INTERLEAVE : ONLY
REC RATE: A 15FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: **** FPS, DURATION: ****
=> (01679 ALARMS CAN BE RECORDED)
ALARM TRIGGER : ALARM
MOTION SENSOR ->