Control Data 3170 Installation Handbook page 200

MSOS BINARY SOURCE 4
MODIFICATION AND FINAL LIBRARY GENERATION
Prior to preparing the final MSOS library, the user must have completed COSY and
COMPASS runs to reassemble the binary deck of each subprogram or routine in which
assembly options are to be changed. In addition, an MSOS library compatible with the
version of MSOS to be installed (interim library or MSOS version 5 library) must be up
and running. This library is used to run a PLIBEDIT job to modify the PRELIB binary
source tape (file). Then the library is used to run a PRELIB job to generate the new
library from the modified binary source file.
4.1 BINARY SOURCE FILE LISTING
Before setting up the job for the PLIBEDIT run, a dummy PLIBEDIT run must be made
to obtain a listing of the PRELIB binary source file.
Example:
$JOB" ,
$EQUIP,01=MT
$EQUIP, 2
=
MT
$PLIBEDIT
(PRELIB binary source tape)
(dummy output file; scratch tape)
ENDEDIT/
77
EOF
88
$EOJ
4.2 PLIBEDIT RUN
PLIBEDIT (section III-7) must be used to modify the PRELIB binary source file before
making the PRELIB run. The following items normally require changes on the
PRELIB binary source file:
1.
Unit Card Replacement. A 7 UNIT,20 card (section III-8) was placed in the
binary source file as a
conv~nience
to those using the extended core variant of
MSOS. During the PRELIB run, the UNIT card causes PRELIB to switch the
input from the binary source tape to unit 20 to add the INITUSER routine to
the library.
If the extended core variant of MSOS is not being installed, use a DELETE /
statement in the PLIBEDIT run to remove the UNIT card from the PRELIB
source tape.
If the extended core variant is being used, mount the release tape containing
INITUSER (package
G)
and equip the drive as unit 20. PLIBEDIT copies the
INITUSER deck onto the new library.
60410800 D
II-4-1