Table of Contents
Advertisement
INTERIM LIBRARY INSTALLATION,
3
HARDWARE INITIALIZATION, AND DECK
PREPARATION
The construction of an operable MSOS system requires the use of the installation utility
package (IUP).
IUP establishes the interim library on the system mass storage device
which is then used for hardware initialization, deck preparation, binary source modifi-
cation, and final library generation.
The user should be familiar with the IUP functions
(part III, section 4).
3.1 INTERIM LIBRARY INSTALLATION AND HARDWARE INITIALIZATION
The following steps must be used to install the MSOS interim library.
1.
Ready the system device.
If it is an 853, 854, or 841, mount the system pack.
2.
Write address (853, 854, or 841) and clear the system pack (part III, section 2).
3.
Establish an autoload routine in memory (part III, section 1).
4.
Mount the MSOS binary release tape on unit 0 or
if
the installation is from
I
cards, place the deck of IUP in the card reader, followed by an EOF card and
the generalized interim library deck.
5.
Autoload from the input unit to initiate IUP (part III, section
4).
6.
IUP types:
I IUP 003 INSTALLATION UTILITY PROGRAM LOADED.
INP
=
LUN
7.
Respond by typing:
TY
8.
IUP types:
A IUP 006 READY FOR INPUT
9.
Respond by typing:
DEV
and press FINISH
IUP now requests the DEV statement parameters.
These statements define the
equipment available to IUP and assign a logical unit number.
When IUP is accepting
a parameter and REPEAT is pressed, IUP:
Repeats the present request if some characters have already been entered for
the request, or
Repeats the previous request, if no characters have been entered.
60410800 D
II-3-1
I
Advertisement
Table of Contents
Need help?
Do you have a question about the 3170 and is the answer not in the manual?
Questions and answers