Control Data 3170 Installation Handbook page 121

5.2 ADAPT
The ADAPT version 1. 1 32K release consists of a magnetic tape containing:
A binary (load-and-go) file from which to make the ADAPT overlay tape
A COSY-formatted source file
ADAPT Internal Maintenance Specifications are available by request.
ADAPT operates from an overlay tape made from either the binary file or the COSY
source tape furnished as a part of the ADAPT system release; ADAP T also operates
from decks punched from the tape.
5.2.1
INSTALL ADAPT USING COSY TAPE
Create the overlay structure from the ADAPT COSY tape. Several methods can be
used depending on the system configuration. The following method assumes the exis-
tence of three magnetic tape drives, a card punch, and the use of APC.
t
1. Mount the COSY tape on logical unit 01 and scratch tapes on logical units
02 and 03.
2. Allocate APC files and initialize APC.
$PRIORITY, P2
$FET, APC, SYSTEM-INPUT, •••
$ALLOCATE, •••
$FET, APC, SYSTEM-OUTPUT, •••
$ALLOCATE, •.•
$FET, APC, SYSTEM-PUNCH, •••
$ALLOCATE, •••
$APCV50
77
88
$EOJ
If the APC system files have already
been allocated, the FET and ALLOCATE
cards can be eliminated.
3. Compile and assemble ADAPT routines using the following cards.
$JOB, •••
$EQUIP, 01=MT, 02=MT, 03=MT
$UTILITY
SKFF,01
END
$COSY
DECK/
(LUN01=ADAPT COSY, LUN02=Hollerith
output for FOR TRAN compilation, L UNO 3 =
Hollerith output for COMPASS assembly)
1=01, H=02
CDCADAPT
(DECK/
H=02 cards for intervening decks)
FLOVER
DECK/
1=01, H=:03
- - - - - -
t
The use of APC and allocation of mass storage files for spooling is discussed in detail in
the MSOS Reference Manual.
11-5-4
60410800
A