Advertisement
1.
Selecting "VCIL Control" page
2.
Press combo box on the channel and select "CAN + Mask" as below figure
Set Mask
1.
Selecting "CAN" page as below figure
Set CAN bus speed. For example 250K
2.
Configure the Message mask
3.
Press "Set Mask" button to apply the mask to bus
4.
You should see the mask was applied on the bus.
5.
If you set a mask to bus. You should not see the specified CAN ID on the
read data list if the ID not passed for the mask
Mask Rule:
The CAN Message ID & operator "Mask" equal the "ID" & operator "Mask"
31
www.advantech.com
Advertisement
