Aj71Pb96F/A1Sj71Pb96F Connection Abort (Abort: Receiver) - Mitsubishi Electric A1SJ71PB96F User Manual

7. COMMUNICATION THAT DO NOT REQUIRE
THE SEQUENCE PROGRAM
7.1.2
An "Abort" service from client is issued to abort the connection with the AJ71PB96F/A1SJ71PB96F.
When the AJ71PB96F/A1SJ71PB96F receive an abort, then a logical connection abort status is
entered.
An "Abort" is automatically issued when there is a PROFIBUS-FMS protocol or parameter error.
[Parameters required by the client]
• Abort Identifier
Point
When the abort is executed by the user created application program, 0 (User) is suitable for the
Abort Identifier value. Other values are used by the communicating device side that is actually
conducting the communication.
• Reason Code
• Abort Detail
[Server (AJ71PB96F/A1SJ71PB96F) return parameter]
None

AJ71PB96F/A1SJ71PB96F connection abort (Abort: Receiver)

This shows from which communication level an abort can be issued.
Abort Identifier
0 (USER)
1 (FMS)
2 (LLI)
3 (Layer 2)
This shows the reason for the abort.
Reason code prescribed by PROFIBUS
This sets the abort detail report.
This parameter usage method is prescribed by the profile supported by the request.
Abort detail information (maximum 16 octet)
Explanation
When aborted by the application
Aborted by FMS
Aborted by LLI
Aborted by layer 2
Reason Code
Abort Detail
7-5
MELSEC-A