Eng] 8.1 [Dksf 48.4 Iu] Configuring Relay Management Modes - NetPing 8/PWR-220 v3/SMS User Manual

[ENG] 8.1 [DKSF 48.4 IU] Configuring Relay Management Modes

Management modes of built-in relays are configured at the page «
This page allows to control eight output channels (relays) of a device power supply. A channel may be switched off for a short time, set to the mode «M
anual Off », « Manual On », « Schedule
Relay Control – is a current status of a relay. It is possible to specify the next values:
Manual Off – a relay is constantly switched off;
Manual On – a relay is constantly switched on;
Watchdog – a relay is controlled by the module «
Schedule – a relay is controlled by the module «
Schedule+Watchdog – a relay is controlled by both modules «
relay on and off. The module «
Watchdog » notices a failure in a device operation (no response to ICMP request), a relay changes its status to the opposite one for a short time;
Logic – a relay is used as a logic output
Switch Off for Short Period (15s) – when clicking the button «
Relay State – is a current status of a relay of each of eight sockets. Possible variants are: «
Outlet is Powered – is an availability of the voltage for every socket out of eight ones. Possible variants: «
A status of a relay and voltage at sockets are updated automatically when a relay status is changed or a voltage is present with no need to reload the
entire page.
Memo – is a field for viewing or changing a brief description of a relay. A value in this field will be used in SYSLOG notifications, records at the page «
LOG », as well as included into SMS, E-mail notifications, E-mail reports about a status of sensors and indicated in headings of pop-up dialogs and
module configuration «Watchdog» and «Schedule». Maximum size is 30 characters.
After setting up all necessary parameters click the button «
Copyright © NetPing east Co., Ltd E-mail:
AC OUTLETS
», « Watchdog », « Schedule+Watchdog
Watchdog »;
Schedule »;
Watchdog
Watchdog » checks the operability of a connected device depending on the module «
Reset », a corresponding relay will be switched off for 15 seconds.
Apply changes
support@netpingdevice.com Phone:+886-2-23121582
» of a device web interface:
», « Logic Output ».
» and « Schedule » simultaneously. The module «
Off », « On ».
Yes
On default : empty line.
».
Schedule » switches a
Schedule ». If the module «
», « No ».