Eng] 2.6. [Dksf 48.4 Iu] How To Reboot A Device - NetPing 8/PWR-220 v3/SMS User Manual

[ENG] 2.6. [DKSF 48.4 IU] How to Reboot a Device?

When rebooting a device through a web interface, its embedded relays are not rebooted! It works only in the case if a firmware version
48.2.5 has been installed when manufacturing a device, which includes an improved firmware loader.
A NetPing device can be rebooted in two ways:
1. Click the button « Reboot»
Afterward, a system will display an informational notification confirming a device reboot.
After clicking the button «
2. Use an SNMP v1 protocol by specifying OID values using the command
OID
.1.3.6.1.4.1.25728.911.1.0 npSoftReboot
.1.3.6.1.4.1.25728.911.3.0 npForceReboot Integer READ/WRITE A
Copyright © NetPing east Co., Ltd E-mail:
at the home page of a web interface of a device.
Continue » CPU LEDs near Ethernet ports will blink. A device will reboot. Its uptime will be zeroed to 0d 0h 0m 0s.
Name Type Access
Integer READ/WRITE Software reboot of a device when writing the value«1» (an analog for rebooting a
support@netpingdevice.com Phone:+886-2-23121582
Set :
Description
device through a web interface)
forced immediate reboot of a device when writing the value «1» (a processor is
reset the same as when turning a power supply on)
DKSF