Eng] 11.3. [Dksf 48.4 Iu] Is It Possible To Reproduce Ir Commands Through Snmp - NetPing 8/PWR-220 v3/SMS User Manual

[ENG] 11.3. [DKSF 48.4 IU] Is It Possible to Reproduce IR Commands through SNMP?

IR commands can be reproduced through an SNMP protocol. A necessary information is in the MIB file, corresponding to the used firmware version
of the NetPing device. It is possible to download the MIB file from the page of a description of a device at the company's website
ice.com/products/netping-8-pwr-220-v3-sms
Reproducing IR commands through the means of an SNMP protocol:
1. Before issuing an IR command, make sure that a transceiver is in a standby mode, reading the status through the OID .1.3.6.1.4.1.25728.7900.1
.3.0 . A value of a status «
command;
2. To issue an IR command, write a command number (a number of a cell with a saved command) into the OID .1.3.6.1.4.1.25728.7900.1.1.0;
3. If a transceiver is in a status of an error, a reset is performed by writing a value « » into the OID
extension module IRC-TRv1);
4. After a reset, there is a need to wait until an IR module is ready, reading its status. If repeated reproducing of an IR command does not break a
logic of equipment operation, then it is better to repeat issuing a command 2-4 times, each time checking a readiness before issuing a command.
All statuses of an IR extension module can be seen in the MIB file
the page of description of a device at the company's website
[DKSF 48.4 IU] What OID Are Supported by a Device?
Copyright © NetPing east Co., Ltd E-mail:
. It is possible to record commands using a device web interface only.
commandCompleted (0) » and « commandAccepted (2)
DKSF_48.4.x_ MB.mib
http://www.netpingdevice.com/products/netping-8-pwr-220-v3-sms
» of the firmware description.
support@netpingdevice.com
» means that IR transceiver is ready to reproduce an IR
1
(OID « npIrStatus
Phone:+886-2-23121582
http://www.netpingdev
.1.3.6.1.4.1.25728.7900.1.2.0 (works for the IR
»), which is available for downloading at
or at the page « 13.3.