Eng] 10.5. [Dksf 48.4 Iu] What Is Snmp Setter - NetPing 8/PWR-220 v3/SMS User Manual

[ENG] 10.5. [DKSF 48.4 IU] What Is SNMP SETTER?

SNMP SETTER is used as an output of a rule of the module «
SNMP v1 protocol. In particular, it is possible to control IO lines and relays of another NetPing device via a network.
To configure an SNMP SETTER, there is a need to go to the page «
In the section « SNMP SETTER
Channel number («SNMP 1», «SNMP 2») – this number is indicated as a rule output.
Memo – is a random text up to 30 characters in length.
Address – is an IP address, to which an SNMP SET command will be sent.
UDP Port – is a port, which listens to an SNMP agents at a remote device.
OID (.1.3.6...) – is an identifier of a variable, which will be set at a remote device. There is a need to indicate a full OID in numerical notation, starting
from .1.3... A list of variables is in the MIB file from a device in a special format or in a documentation of a device. It is possible to use a free piece of
software iReasoning MIB Browser
variables. On default : .1.3.6.1.4.1.25728.5800.3.1.3.1
Сommunity – is an SNMP Community of a record, configured at a remote device.
«On » value (type Integer32) is a value, which will be recorded into the OID at a remote device when invoking the action « –
« On » or through an output of a logic rule. Type of the value is 32-bit signed integer.
« Off value » (type Integer32) is a value, which will be recorded into the OID at a remote device when invoking the action « –
« Off », or through an output of a logic rule. Type of the value is 32-bit signed integer.
Test it– when clicking the buttons «
Status – several seconds after sending a request to set a variable in the field «
received, and a variable is set successfully. «
device, its failure, incorrect IP address, port or community. Other variants mean that a response with an error code has been received, and its textual
explanation is displayed in a status line.
After changing the settings, click the button «
After configuring an SNMP SETTER, there is a need to configure a rule in the module «
10.2. [DKSF 48.8 IU] How to Use the Module «Logic»?
Copyright © NetPing east Co., Ltd E-mail:
Logic
» the next parameters are configured:
On default empty line :
or any similar software for convenient browsing the MIB file in an appearance of a tree and checking functions of
On » or « Off », a device immediately sends corresponding requests with values «
Timeout » means that confirmation is not received. It can be a result of an unavailability of a controlled
Apply changes ».
».
support@netpingdevice.com
» and is designed for setting an SNMP OID variable at a remote device via an
LOGIC » of a device web interface:
On default empty line :
On default : 161
On default : empty line
On default : 1
On default : 0
Status » a result « ОК » is displayed. This means that a confirmation is
Logic ». It is possible to learn how to do this from the section «
Phone:+886-2-23121582
On », by clicking the button
Off », by clicking the button
On » or « Off ».