NetPing 8/PWR-220 v3/SMS User Manual page 88

RELAY 4 Relay on the channel
OUTLETS» before using
RELAY 5 Relay on the channel
OUTLETS» before using
RELAY 6 Relay on the channel
OUTLETS» before using
RELAY 7 Relay on the channel
OUTLETS» before using
RELAY 8 Relay on the channel
OUTLETS» before using
SNMP 1 SNMP Setter 1. It must be configured at the page «
SNMP 2 SNMP Setter 1. It must be configured at the page «LOGIC» before using
IR 1 IR command 1. A command must be recorded and saved into the cell 1 at the page «
IR 2 IR command 2. A command must be recorded and saved into the cell 2 at the page «IR COMMANDS» before using
IR 3 IR command 3. A command must be recorded and saved into the cell 3 at the page «IR COMMANDS» before using
IR 4 IR command 4. A command must be recorded and saved into the cell 4 at the page «IR COMMANDS» before using
SMOKE Reset of all connected smoke sensors is activated.
RST
8. Buttons Move Up/Move Down
The buttons are designed for changing a position of a rule in the list, thus changing a priority of a rule. If rules form conflicting commands for an
output, then a rule which is higher in the list will work. However, «
mutual location in the list.
9. Controls
Controls work directly when clicking them. There is no need to click the button «
The buttons « Start » and « Stop
a warning line of a logic status « » appears.
The button « Reset » sets the outputs controlled by a logic module to the specified initial status « » (off), and initiates a reset signal. Rules, which have a
«RESET » signal as an input, may switch outputs to the other required initial status. There is a need to take into account that if rules are not stopped
before clicking the button « Reset
10. Status Line
If rules operation is stopped, then a warning line will appear.
11. Button for Saving Changes
After setting all necessary parameters, click the button «Apply changes».
Copyright © NetPing east Co., Ltd E-mail:
4, built into a body of a device A relay control must be set to the mode «Logic Output» at the page «AC
5, built into a body of a device A relay control must be set to the mode «Logic Output» at the page «AC
6, built into a body of a device A relay control must be set to the mode «Logic Output» at the page «AC
7, built into a body of a device A relay control must be set to the mode «Logic Output» at the page «AC
8, built into a body of a device A relay control must be set to the mode «Logic Output» at the page «AC
» control starting and stopping of rules operation. This status is saved when a device is switched off. If rules are stopped,
10
», a status of outputs can be changed immediately and a reset command will not have any external effect.
support@netpingdevice.com
.
.
.
.
.
LOGIC » before using
IR COMMANDS
While » rules always have a higher priority in relation to « » rules, regardless their
Apply changes » additionally.
0
Phone:+886-2-23121582
» before using
If