NetPing 8/PWR-220 v3/SMS User Manual page 118

NP WRONG PASSWD IN kkkkkk
NP WRONG PASSWD
where:
kkkkk – is a request identifier (random number from 3 to 9 numbers). It is repeated in a response for a compliance between a request and a response. It
is an optional element of a command. If there is no identifier in a command, there is no identifier in a response (the second command)
Response Messages to SMS Commands of Request Status
Response to a request (NETPING Lm? kkkkkk) of an IO line:
NP REPLY L1=0 kkkkkk
A value L1=0 is given for an example. Before a character «=» there is a line number, after a character «=» there is a logic level of a line.
A response to a request (L?) of a status of all IO lines:
NP REPLY L1=0 L2=1 kkkkkk
Values L1=0 L2=0 are given for an example. Before a character «=» there is a line number, after a character «=» there is a logic level of a line
A response to a request (NETPING Pn? kkkkkk) about a relay status:
NP REPLY Pn+ (0 RESETS, 0 REP.RESETS) kkkkkk
where:
Pn+ – is a relay status
n is a relay number –
A relay status is encoded by characters «+» (switched on), «-» (switched off), L (controlled by a logic). In parentheses, there is a total reset counter and
a counter of repeated unsuccessful resets, initiated by the module «Watchdog»
A response to a request (NETPING P? kkkkkk) about a status of all relays:
NP REPLY Pn+ PnW PnL PnX PnS Pn- Pn+ PnS kkkkkk
where:
Pn+ PnW PnL PnX PnS Pn- Pn+ PnS – is a relay status
n is a relay number –
A status of a relay is encoded the same as an SMS command of a relay management. Reset counters are not included into a response
A response to a request (NETPING S?
NP REPLY S1(1..4) =1 B+ R+ S2(5..8) =2 B+ R- AC1+ AC2+ kkkkkk
where:
S1(1..4) is the first group of sockets, numbers 1..4 –
S2(5..8) is the second group of sockets, numbers 5..8 –
B+|B- «+» or «-» means allowed or forbidden backup reserving for a group –
Copyright © NetPing east Co., Ltd E-mail:
kkkkkk) about a status of inputs:
support@netpingdevice.com Phone:+886-2-23121582