How To Do This - NetPing 8/PWR-220 v3/SMS User Manual

[ENG] 5.5. [DKSF 48.4 IU] I Want to Configure Sending Notifications When a Humidity Sensor Status Is
Changed. How to Do This?
Sending notifications when changing a
When clicking the button « Setup
with an embedded GSM modem) and SNMP Trap:
where:
Humidity is above Safe range – is a checkbox, when checked a device will send notifications if a relative humidity exceeds an upper limit of a safe range
of a humidity sensor. On default
Humidity is in Safe range – is a checkbox, when checked a device will send notifications if a relative humidity returns into the limits of a safe range of a
humidity sensor. On default : checkbox is not checked
Humidity is below Safe range – is a checkbox, when checked a device will send notifications if a relative humidity dropped below a lower limit of a safe
range of a humidity sensor. On default
Sensor Fault – is a checkbox, when checked a device will send notifications if a connection with a sensor is lost.
Include in Summary Report – is a checkbox, when checked reports about a sensor status will be sent via e-mail and/or SMS (in a device with an
embedded GSM modem). Time for sending reports is configured at the pages «
After setting all necessary parameters, click the button
Copyright © NetPing east Co., Ltd E-mail:
status of a humidity sensor is configured at the page «
», a menu of settings appears to configure sending notifications of the next types: Log, Syslog, e-mail, SMS (in a device
: checkbox is not checked
: checkbox is not checked
«Apply changes»
support@netpingdevice.com
HUMIDITY
SMS » and « E-MAIL ». On default
.
Phone:+886-2-23121582
» of a device web interface:
On default : checkbox is not checked
: checkbox is not checked