[Eng] Plugging, Installing And Initial Configuring Of A Device - NetPing 4/PWR-220 v4/SMS User Manual

[ENG] NetPing 4/PWR-220 v4/SMS, User guide -[ENG] Plugging, Installing and Initial Configuring of a Device

[ENG] Plugging, Installing and Initial Configuring of a Device

To prepare a device for operation, do the following:
1. Take a device out of a package and install at a horizontal surface or fix it in the 10" or 19" 1U rack.
When installing a device into a 10" rack it is enough to use mounting brackets included into the
shipping kit.
When installing into a 19" rack it is possible to install 2 devices into one 1U 19" slot. In this case,
each device will be fixed to the rack by one mounting bracket (as shown at the picture).
When installing a device on the table or at the wall mounting brackets are turned on 90 degrees
and fix a device to the surface. In this case, 2 brackets are fixed to the case of a device
diagonally.
2. Plug a power cord into a device.
3. Insert the SIM card into a corresponding slot at the front panel of a device until it clicks .
Pay attention to turn the SIM card contacts down.
SIM card must be inserted only into a device cut off power.
4. Plug an external GSM antenna into a corresponding slot at the front panel of a device.
5. Plug external sensors to the device (see detailed information in the section «Connecting External Sensors»)
and/or a load (details on connecting are described in the section «Plugging Load»).
External sensors and/or a load must be connected to a device cut off power.
6. Plug a device to a supply network with a voltage of 110В-220V and a frequency of 50/60 Hz.
[ENG] Plugging, Installing and Initial Configuring of a Device
or
–