Eng] 11.1. [Dksf 48.4 Iu] How To Record Ir Commands Properly - NetPing 8/PWR-220 v3/SMS User Manual

[ENG] 11.1. [DKSF 48.4 IU] How to Record IR Commands Properly?

An IR Control module works with an IR transceiver IRC-TR v2. The transceiver can record and reproduce IR signals from remote controls of home
appliances.
To record IR commands, there is a need to go to the page «
New IR commands are recorded in the section «
1. Prepare an IR remote, from which it is necessary to capture a command.
2. Make sure that a red LED on the IR transceiver glows steadily
3. Choose a command number « » and enter its description into the field «
4. Click the button « Start recording
transceiver will go to a standby mode. A remote and a transceiver must be disposed coaxially at the distance of 10-30 cm for an «eye» of a
transceiver to see a transmitting IR LED of a remote. A command will be recorded.
5. Check a recorded command by clicking the button «
6. Click the button « Save
It is desirable to check again the operation of an IR command by clicking a corresponding button « » in the section of saved commands.
Copyright © NetPing east Co., Ltd E-mail:
IR COMMANDS
IR COMMAND RECORDING
N
». Send a command from an IR remote 30 seconds after clicking the button «
Play/Test
» to save a command in a nonvolatile memory if a command is successfully reproduced.
support@netpingdevice.com
» of a device web interface:
»:
Memo (device, command)
».
>
Phone:+886-2-23121582
».
Start recording ». Otherwise, a