Table of Contents
Advertisement
Important! Sensors of a dry contact type, a
IO lines of a device. You can plug any four sensors out of this set.
Important! A corresponding IO line should be set to an input mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
Supply Voltage Sensor
A supply voltage sensor
matter.
Sensor Flex
First wire
Second wire
Important! Sensors of a dry contact type, a
IO lines of a device. You can plug any four sensors out of this set.
Important! A corresponding IO line should be set to an input mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
IR
Transceiver IRC-TR v2
IR transceiver is plugged by a four-wire line according to the table:
Sensor Flex
Labeled wire (red)
Second wire after a labeled one
Third wire after a labeled one
supply voltage
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
is plugged by a two-wire line according to the
supply voltage
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
[ENG] NetPing 8/PWR-220 v4/SMS, User guide -[8PWR] Sensors Plugin
sensor, a leakage sensor, and others are plugged to
table. An order of plugging wires does not
NetPing 8/PWR-220 v4/SMS Terminal
One of IO lines – 1/2/3/4
sensor, a leakage sensor, and others are plugged to
NetPing 8/PWR-220 v4/SMS Terminal
C
D
+
2
. Maximum allowable length of a
G
2
. Maximum allowable length of a
[8PWR] Sensors Plugin
–
Advertisement
Table of Contents
