Setting The Basic Information - Mitsubishi Electric AG-150A Instruction Book

7-5 Setting the Basic Information

Touch the [Unit Info.] tab in the screen that appears when [Initial Settings] on the menu bar in the setting change window is touched to
open the Unit Info setting window and make the basic settings for AG-150A such as its name and display options.
Note: If the user logs in as a building manager, the operations may be prohibited.
Name field button
Unit ID field button
EC connection
setting button
Volume control
button
Brightness control
button
7-5-1 Unit Setting
Information about the unit is entered on the window below.
Name button
Unit ID button
(1) Press the [Name] button and enter the name for AG-150A in 40 characters or less. The name set here is used on the display screen
of the software that controls multiple AG-150A units and for the name of the sender in the body of error messages.
Note: The following characters cannot be used in the name: < > & " '
(2) Press the [Unit ID] button and enter the ID number for AG-150A in six numerical characters (single byte) or less. Use this setting
when you want to control multiple AG-150A units with unit IDs. The unit ID that is entered here will be used on the display screen of
the software that controls multiple AG-150A units and for the sender ID in the body of error messages.
(3) When connecting an expansion controller, press the [EC connection setting button] and select [Use].
* When the EC connection setting is set to [Use], be sure to make the EC controller settings on the Network settings window.
(4) Press [Save settings] on the Unit Info window to save the settings.
Save Settings
– 53 –
Date format setting
button
Time format setting
button
Temperature unit
setting button
Language
selection button
Screen lock button
Test run enable/
disable button
Room Temp Disp.
selection button
EC connection
setting button